Application Data Sheet - Water Cut Analyzers

Date Requested:
Representative:
Customer Contact:
Address:
Date Required:
Phone:
Phone:
Fax:
E-mail:
 

Field Conditions & Connections

Critical Process Information Units of measure Min Normal Max Measured Range
Temperature
Pressure
Flow Rate
Oil Density
Flange Rating ANSI 150 ANSI 300 ANSI 600 ANSI 900
Flange Type RF RTJ Flat Face Threaded
Pipe U Z L Insertion

Mandatory Information Needed for Full & High Range: Check Box on Right of Selection

Critical Process Information Units of measure Min Normal Max Measured Range
Salinity
Specify Water Cut Range
Pipe Size 1" not Avail. 2 inch 3 inch 4 inch Insertion

Mandatory Information Needed for Low & Mid Range: Check Box on Right of Selection

Critical Process Information Units of measure Min Normal Max Measured Range
Specify Water Cut Range
Specify Largest % Known Water
Pipe Size 1 inch 2 inch 3 inch 4 inch Insertion

Electronic Area & Power Requirements: Check Box on Right of Selection

Area Classification Class 1 Div. 1 NEMA-4
Power Requirement 120 VAC 60 Hz 230 VAC 50 Hz 24 VDC 120 VAC 50 Hz
Cable Length 20 feet 50 feet 100 feet 150 feet Special feet
Certification None FM CSA Cenelec
Communication PDI ASCII Modbus RTU HART®
Software Option 4-20 mA Stream Select Emulsion Phase Relay Output Dual Pulsed Relay Output

Describe Product Type: (Crude, NGL, Condensate, Kerosene, etc.)

Brief Application Description: (i.e.) Test Separator, Truck Pit, Well Production)

Use the space below to further describe the installation details.